Wait and Load Skip Service

When you have a large amount of waste to remove from a home or commercial building, hiring a skip is the obvious answer. Sometimes, however, there isn’t an area to place the skip for any length of time. This might be due to parking restrictions, a congested street, a narrow lane or you may need a permit and haven’t had time to apply for one. Whatever the reason, the skip service you need is a Wait and Load service.

What is a Wait and Load skip service?

In a nutshell, the skip lorry waits while you load. It is a rapid turnaround service that makes sure the skip is on the ground for a minimum amount of time. Book the skip and it will be dropped off, left for 30 to 60 minutes as prearranged, and then collected and taken away again.

Wait and Load is a highly efficient way to get rid of building, home and garden waste. It is quick, convenient and clean. It can save on council permit costs and the time it takes to arrange them, and it can ease problems with nearby residents when space is tight. It’s a rapid service with very little fuss – so speedy your neighbours won’t even have time to notice a skips’s been there.

Tips on getting the most from a Wait and Load skip service

As time is of the essence with this service, it is very important to be as prepared as possible. Make sure all the waste you need to dispose of is as close to the access as you can get it ahead of time. So anything upstairs, get downstairs – anything near the back of the building, get to the front etc. Pack it into easy-to-move containers if you can, so you can get it out and into the skip with ease. Make sure you have as many people helping as possible, and that they are all ready to move when the skip arrives. Have everyone suitably equipped with gloves, masks and boots where needed. Get a wheelbarrow or trolley ready to speed things along too. Being prepared is key to getting the best out of the Wait and Load service so take a little time to organise your waste, and things will go without a hitch.